1968 Barracuda Notch 340
My hope was to get both mufflers to oppose each other equally in all respects but with the drive shaft 2.5" off-center to the passenger side gonna be another compromise. I need about a 3" jog for the passenger side muffler. Muffler shop explained why his bends would require 10" of radius distance, thought his squished 90's could work, no go there. Bought a mandrel Bent U from Summit for like $20( notice no squish deformation in the radius), cleared and leveled the bed on my tired old chop saw, added a temporary fence at the 2.75" I needed per piece for total jog distance with a psuedo bed for the leg and made 2 identical cuts, should work fine. Tomorrow Im hoping to install the finished driver side exhaust and move on with the passenger side.
My hope was to get both mufflers to oppose each other equally in all respects but with the drive shaft 2.5" off-center to the passenger side gonna be another compromise. I need about a 3" jog for the passenger side muffler. Muffler shop explained why his bends would require 10" of radius distance, thought his squished 90's could work, no go there. Bought a mandrel Bent U from Summit for like $20( notice no squish deformation in the radius), cleared and leveled the bed on my tired old chop saw, added a temporary fence at the 2.75" I needed per piece for total jog distance with a psuedo bed for the leg and made 2 identical cuts, should work fine. Tomorrow Im hoping to install the finished driver side exhaust and move on with the passenger side.