removing spider gears 7.25
ok pry that centre out
normally you would flex the case but a pry bar will ping it out along with its beraimgs and shims
stand center it in a vice with the bolt heads upwards
and undo the bolts that hold both parts of the centre together (not the bolts for the ring gear)
take off the top half bits will fall out
don't loose any little dowels that old the cross pin in place
pull off the spider gears and any cupped shim washers
whether its an open centre a cone centre or a clutch centre there is nothing much in there and its all pretty obvious once you see....
id normally try to keep my side gears and spider gears together...
side gears that have smashed spider gears will be marred by the incident so a complete set is a better bet.
Job done
possibly easier just to sell the whole centre with or without ring and pinion which again should be kept as a pair, preferably greased to stop the rust.
Dave