Holley Gen 3 Hemi Swap Sale
Probably not just mine, but does your "X Pipe" look more like a cross between the pictured X Pipe and an "H" Pipe.
That is with a short length of 2.5" pipe in between, connecting instead of like shown?
Picture these cut apart at the weld and then connected back together by a ~3" length of 2.5" pipe...
Then there's the holes they cut in the longer tubes for the crossover, they are only about the size of my thumb... should be closer to 2.5" diameter to match the pipe diameter... SMH.
Going to cut them apart at the center of the short H pipe and open up those crossover holes to the diameter of the H pipe and then install them. Will decide disposition of the short H pipe when it's time for final assembly. I think it will be just fine, maybe couple it back together with a sleeve/clamp, maybe weld it.
We'll see...
Probably not just mine, but does your "X Pipe" look more like a cross between the pictured X Pipe and an "H" Pipe.
That is with a short length of 2.5" pipe in between, connecting instead of like shown?
Picture these cut apart at the weld and then connected back together by a ~3" length of 2.5" pipe...
Then there's the holes they cut in the longer tubes for the crossover, they are only about the size of my thumb... should be closer to 2.5" diameter to match the pipe diameter... SMH.
Going to cut them apart at the center of the short H pipe and open up those crossover holes to the diameter of the H pipe and then install them. Will decide disposition of the short H pipe when it's time for final assembly. I think it will be just fine, maybe couple it back together with a sleeve/clamp, maybe weld it.
We'll see...