Building a new 505 With Callies / Mopar Performance Block

ValiantS said
As has been eluded to...with the real springs, you'll probably NET about .025" less lift. How does the sweep look? Have any pushrod interference? I usually trim the excess gasket out of the valley. What diameter and wall pushrod do you plan to use?

The radial looks good. Approx .120. The sweep on the valve stems looks good. The picture did not turn out so good will try again later. I am going to call pushrod manufactures later this week it looks like from testing with my 5/16 checking pushrods that I will have room for 3/8 pushrods. But I want to ask them about wall thickness and 11/32 pushrods just to get their opinion. As of now I believe I would order 11/32 or 3/8 .120 wall pushrods. Pushrod length is 9.620 on the exhaust and 9.660 on the intake. I will have to check with pushrod manufacture as most only come in .025 or .050 lengths if my memory still works.