SBM Port Molds

SBM Port Molds

And the pot stirs on!!!!

Go NBT! Stir that pot! Twist up words and meanings and assume some more and more and more. LMAO!

Newbomb Turk said
Let’s see. I said stick a piece of string in the port. You can learn a ton from that.

Good advice

Newbomb Turk said
And then it became about seat angle. Why should I explain something to you that you are incapable of understanding?

So you assume I don’t understand. But this you know I do and you said it for one purpose only…

Pot stirring….. LMAO

Newbomb Turk said
Let me say it this way so maybe you can grasp it.

Not I but for those that don’t know- YES DO SO!

Newbomb Turk said
Are you getting ANY of this? I can’t make it any more simple than that.

know this stuff, next! And moving along moving along….

Newbomb Turk said
Again, if you live and die by the flow bench you will never figure it out.

Everyone should read that again

Newbomb Turk said
Just like the 100% idiotic notion that a 30 degree seat, with whatever limit you put on lift (let’s say you decide you want to run .480 lift convention says that should be a 30 degree seat) is a proven power maker. It’s not. Not with any lift constraints.

That’s why I said (if you were paying attention) that lift does NOT matter when choosing a valve job.

And so the suggestion is there is only one way to do it and everyone else is wrong.

Newbomb Turk said
Think on this. Or not. Some of you can’t learn. You’d rather argue that your way of doing things is all that.

So you assume again.

Terrific pot stirring!!!! Everyone is wrong but you!
LMFAO!!!!