Am I Going To Be Happy With This Camshaft?

I appreciate all of the input. Like I said, I already have a very similar spec cam. Hell, I think its the same cam that I left the link to. It is made by Isky also. One lobe is .005 shorter than the rest but one lobe is also .003 taller than the rest. Maybe this is normal and nothing is wrong with the cam? Just throw some new lifters on it? The rest are at .283, .284 and .285. Most are at .285. I sure hate to be a cheapskate at this point but maybe it's perfectly usable. I did drive the car with that cam with a different 340. It had the wrong converter but it ran pretty good.
That engine had other issues too but it had a nice sounding idle and pulled pretty good on the top end. I still need to buy a converter but I think it wont need a lot of stall. I don't know the tire height yet. I want tall tires. Hoping to get a tucked look but that's tough to do on a barracuda. Its dropped in the back.

I also mini tubbed it with the spring moved inboard and moved back one inch. I just want to get this engine sealed up for now. I still have to measure for pushrods. This is where all of this started. It has PRW stainless rollers if I didn't already mention that. A bigger cam sure aint out of the question. The Promaxx heads will go to .575 lift.