A518 46RH rebuild

MonkeyMadness said
Okay so after work I reassembled the over drive tail housing and got the measurements you needed. The hydraulic tubes extend past the edge of the case by 0.236" just under 1/4". I also got the measurement off the front case where the tubes intersect and it protrudes into the tale housing 0.416" for a total of 0.652" of contact. Hope this helps..

View attachment 1716203057

View attachment 1716203058

View attachment 1716203059

View attachment 1716203062

View attachment 1716203064

That helps tremendously! Just measured mine and the tubes stick out 0.260" from the mounting surface, so I should be good. I got scared when I saw the tips of the tubes kind of flattened, but looks like yours are like that too, so that definitely eases my mind. Thank you again! I appreciate it.