Who would like to beta test one of my new voltage regulators?
I decided to use the spade terminal version rather than the motorsport connector version - I was feeling lazy and didn't want to run an extra wire. The 3D printed adapter means I can easily switch back if anything breaks on the test run.
Ran for 20 minutes without any trouble. Next step will be to lay out the production board with a stock type connector. Is there any interest in the motorsport connector version as well? Because this is going to take two circuit boards with the way I plan to set up the stock connector.
I decided to use the spade terminal version rather than the motorsport connector version - I was feeling lazy and didn't want to run an extra wire. The 3D printed adapter means I can easily switch back if anything breaks on the test run.
Ran for 20 minutes without any trouble. Next step will be to lay out the production board with a stock type connector. Is there any interest in the motorsport connector version as well? Because this is going to take two circuit boards with the way I plan to set up the stock connector.