360 intake fit problem??
I am building a 408 stroker and have a 1973 360 block with Trick flow 190 heads and a trick flow track heat intake. It seems like the intake is too far from the heads. When I tighten it down, it appears to bend or angle the intake slightly to get it to bolt up tight. I'm guessing it would leak. Before I take it back off, I'm looking for some help. Perhaps I have the wrong intake gaskets, but I was hoping to get some feedback. Thanks.
Brian
I am building a 408 stroker and have a 1973 360 block with Trick flow 190 heads and a trick flow track heat intake. It seems like the intake is too far from the heads. When I tighten it down, it appears to bend or angle the intake slightly to get it to bolt up tight. I'm guessing it would leak. Before I take it back off, I'm looking for some help. Perhaps I have the wrong intake gaskets, but I was hoping to get some feedback. Thanks.
Brian