Stroker's 68 Barracuda

stroker416 said
That's a great idea on stacking the plates and welding them into one unit.

Thanks! I think I will do some work this evening to see what the weight might be. I expect it will be heavy, but if it is twice the weight of the original spindle, might not be the greatest idea.

stroker416 said
Ever think if adding a few extra offset/varying holes in each plate to add a few rosette welds in between each piece to give it a little more grab?

I did, the holes just below the UBJ mount are there just for that. But I didn’t think about ones around the hub itself. That’s a great idea.

stroker416 said
I like the lower ball joint bolt pockets. Eliminates a wrench, that's cool.

That was kind of out of necessity. The hub covers the bolts and the bolts are too close to the hole to leave wrench clearance. And even worse, the hub has to be bolted to the spindle before the LBJ can be bolted on.