74 Dart 360 Sport
Lol I'm not going to say it's perfect yet we're closer I am becoming my own worst critic. Local guys that own shops looked at it said you did it. Couple little brackets they pointed out for the holes and plates which I already planned to do was mentioned. Least they don't grone dear gawd what has Vince thought up now hahahah. Others may say you cut up the car well it's just a little A body and I am making it looking pretty ground down seam sealer and will undercoat and paint it.
Besides the obvious this old bench was killing my back and I saw some rust I didnt know about metal thinner than it appeared. I repaired it all with 14 guage so if I did again and I had car 90 percent tore down I would have had it blasted and whole floor pan and the rocker repair fixed up with a full trunk pan even to though old repaired fine. I also would have done a flat floor pans and conversion to a QA1 coil over rack. I wanted the car on the road and my impatient self got the better of me. Sometimes I forget this little car came from Rochester New York and then moved 45 miles from Canada for its next life in New Baltimore Michigan.
Today's plan is the passenger seat and wire up the electric seat two wires what could go wrong right wink! FYI I think Challenger seat is little wider and bigger bolster could have its own issues I would measure this seat cushion bottom was 19 inches each bench split is 25 wide total of 50 inches. Dion I know you like a console something to consider more narrow the seat the better the console is. Seat top is six inches from headliner.
I will measure shortly and post a picture. They are taller seats compared to bench, factory or sport bucket or shorty bucket. They were not 500-1000 for just the seats and some cheap knock off not matching the car. I have 85 dollars in the seats and some gas/mig time and of course engineering it.
Lol I'm not going to say it's perfect yet we're closer I am becoming my own worst critic. Local guys that own shops looked at it said you did it. Couple little brackets they pointed out for the holes and plates which I already planned to do was mentioned. Least they don't grone dear gawd what has Vince thought up now hahahah. Others may say you cut up the car well it's just a little A body and I am making it looking pretty ground down seam sealer and will undercoat and paint it.
Besides the obvious this old bench was killing my back and I saw some rust I didnt know about metal thinner than it appeared. I repaired it all with 14 guage so if I did again and I had car 90 percent tore down I would have had it blasted and whole floor pan and the rocker repair fixed up with a full trunk pan even to though old repaired fine. I also would have done a flat floor pans and conversion to a QA1 coil over rack. I wanted the car on the road and my impatient self got the better of me. Sometimes I forget this little car came from Rochester New York and then moved 45 miles from Canada for its next life in New Baltimore Michigan.
Today's plan is the passenger seat and wire up the electric seat two wires what could go wrong right wink! FYI I think Challenger seat is little wider and bigger bolster could have its own issues I would measure this seat cushion bottom was 19 inches each bench split is 25 wide total of 50 inches. Dion I know you like a console something to consider more narrow the seat the better the console is. Seat top is six inches from headliner.