4 speed 4 door

74valiant said
Haven't seen much discussion on putting a four-speed in a four-door but I imagine it would be the same process as a two-door? I have a 74 Valiant with a 408 Stroker motor that I'd like to put a four-speed behind. From what I've read, non overdrive would be what I want with the iron case. Any specific years or part numbers to look for? I saw there was a couple different bellhousings but couldn't figure out if they all worked or not. Any help would be much appreciated. Also does the floor pan transmission hump fit the same on a four-door as a two-door? If somebody has a full Dropout kit from a donor car that they're looking to sell I would be interested. Located in Michigan

Now this is an a-body I would like to see when its finished!

Here's the 4-speed hump. Should fit fine.

If you are going to be using the stock bench seat, some mods to the shifter handle may be in order.

I'd cut the floor and mount the trans first before doing any welding.. Then , position the hump for correct fit with the bench seat in place also.

Go to Brewers Transmissions or Passon transmissions web sites for trans info. They are both very reputable.

Post some pics of your progress!!