Some snags with my conversion
Ok so ready to testing but something does not look right. I measured my air gap about 10 times. With it installed, there is a space between the face of the bearing and the fingers of about .145 using a piece of metal as a feeler gauge. While that seems correct it looks cavernous to the eye. Is this correct? Did I do something horribly wrong? I’m on the home stretch of buttoning stuff up so I’d rather pull trans now to re shim before more stuff gets bolted on
It is fully compressed, I have not put fluid to it yet, so maybe it pre loads further out?
Ok so ready to testing but something does not look right. I measured my air gap about 10 times. With it installed, there is a space between the face of the bearing and the fingers of about .145 using a piece of metal as a feeler gauge. While that seems correct it looks cavernous to the eye. Is this correct? Did I do something horribly wrong? I’m on the home stretch of buttoning stuff up so I’d rather pull trans now to re shim before more stuff gets bolted on
It is fully compressed, I have not put fluid to it yet, so maybe it pre loads further out?