Classic auto air install 1970 Duster with 340 and Edebrock Super Victor EFI Manifold
I cut and modded my glovebox - the JB Weld Plastic Weld worked good, but I got some runs. Not a big deal since you never see it anyway. For some reason I had to cut the upper corner because of the pinch weld on my car...This is a later plastic glovebox. Now it fits fine.
Interior is back together. My heater controls bezel took a beating from my friend 3D scanning it. Hope at some point we get out design done and can swap it out.
Today was the first day I fired it up. I have a coolant leak at the power steering bracket bolts in the block I need to fix. Then all that's left is charging it. I didn't check yet to see if it held a vacuum all winter.
I cut and modded my glovebox - the JB Weld Plastic Weld worked good, but I got some runs. Not a big deal since you never see it anyway. For some reason I had to cut the upper corner because of the pinch weld on my car...This is a later plastic glovebox. Now it fits fine.
Interior is back together. My heater controls bezel took a beating from my friend 3D scanning it. Hope at some point we get out design done and can swap it out.
Today was the first day I fired it up. I have a coolant leak at the power steering bracket bolts in the block I need to fix. Then all that's left is charging it. I didn't check yet to see if it held a vacuum all winter.