'69 Barracuda door glass, front up stop?

Super-Cuda said

This is accurate!


Hand tighten the adjustment bolts so that they are tight but moveable.

Then use slight movements to adjust into place.

This will work but takes a few movements to get right.

I hope you didn't remove the rear glass LOL !!

You think this one is hard to adjust, wait until you try the rears!! LOL !!

Click to expand...

The rears I drench with WD40 then white lithium grease new cat whiskers those are aligned well and go up and down fine. So not messing with them anymore.

The passengers side 1/4 panel was hit hard when original owner had car. I think pass side door bent where it meets 1/4 panel and was damaged too. Orig owner did a lot of drinking driving and no sheet metal forward of doors is original. So at some point someone messed this passengers door glass alignment up cause its been messed up since 1979 when I bought the car.