I doubt it. In most cases you want less timing at peak torque and more timing at peak power.
If you make peak torque at say, 3500 (that’s probably a bit low but that’s a close guesstimate) and you have your timing all in by then (or if it comes in even earlier than that) you are killing power at peak torque.
With your cam I would guess (at least as a starting point) 18, maybe 20 initial and by peak torque I would be around 24-26 and once you are past peak torque you want the curve to gain 1.5-2.0 degrees per thousand RPM. So that would mean at 6000 you should be 31-33 total.
If you are using a Chrysler distributor you will need to reduce the weight of the weights to slow the curve down, otherwise you will need to use springs that will close a barn door to get the curve correct.