340 exhaust heat shield needed for Van's to repop.

Progressive Die Metal Stamping Press Video TADA this is a good example as the part is strip fed, auto lubricated, and there is a set of shaker trays underneath the die set for scrap. Once the coil is loaded the press runs in continuous mode of operation until the coil runs out. If you watch the part progression the forming is done at the at the end progression cut and ejected. Some strip feeders even have multiple coils and tig weld the coils together with a slack loop so the press never stops all day. They are kind of flirting with disaster here as it doesn't look like they are verifying the part is ejected. The red control boxes on the press are Honeywell Wintriss die pros. They can be easily programmed based upon the degree angle of the press coupled to a ferrous metal proximity to prove the finished part has ejected from the die before the next stroke. If the Honeywell does not see the input become set it will immediately stop the ram to prevent die damage.