74 Dart 360 Sport
Finished up cleaning up welds test fitted many times rear mount. I ran tranny lines and fuel with pfte. These fittings are ok but seems legit garage has a better one that sticks out little farther. I chose not to go under engine and went left side and up for my lines. I will put a heat wrap for the two feet near the headers for gas and trans lines.
I have a new filter and pan coming will do that as well. Then I can fill this up and get ready for tunnel and start up. I know it is slow going but I'm trying to take my time here and it's coming together nicely. I need to get some brackets for a few spots and rubber edging for couple sheet metal spots. I need to draw out a lower support will go under transmission and bolt to lower side of cross member I want it there for bracing and strength.
Finished up cleaning up welds test fitted many times rear mount. I ran tranny lines and fuel with pfte. These fittings are ok but seems legit garage has a better one that sticks out little farther. I chose not to go under engine and went left side and up for my lines. I will put a heat wrap for the two feet near the headers for gas and trans lines.
I have a new filter and pan coming will do that as well. Then I can fill this up and get ready for tunnel and start up. I know it is slow going but I'm trying to take my time here and it's coming together nicely. I need to get some brackets for a few spots and rubber edging for couple sheet metal spots. I need to draw out a lower support will go under transmission and bolt to lower side of cross member I want it there for bracing and strength.