Finally have this set of 2.08 Edelbrock heads done.

pretty good numbers. My old Eddy's just came back from a professional porter who just retired from a big name company. I got lucky to get his name. They also have the 2.08 intake. I ran them a couple years as ported by my local machinist. The new guy also did my S Victor. wish I had taken better pics, but it's all together now.
The flow sheet has the first column as ported locally. Column 2 is what the new guy did. Amazing numbers...especially mid lift. Keep in mind my bolt holes are tubed, and I run push rod oiling, so I think that explains a little.
All this preserving the short side as much as possible. He said most of the increase came from the roof and a different valve job.

View attachment 1716245428

View attachment 1716245429

View attachment 1716245430


Those should work nicely. My numbers are down on my last two sets because my customers held me back from what I’m used to doing as far as chamber work. Those were my last two sets of heads where the customer dictates that. A 2.08 valve should easily be over 320 cfm without restrictions on chamber. It causes me more work and not as good a set of heads for the customer.