12:05 Garage- ’70 Duster build

Here's the new throttle body adapter I made that is raised over the last one. I lined up the bottom of the hole and rounded the top. The picture makes the bottom look like it isn't aligned but it is.
t-body adapter.jpg
These gates shrink clamps are badass! So much better looking than a screw clamp.
hose clamp.jpg
Got the IAT bung welded in. just need to cerakote the tube.
IAT.jpg

For those not following my summarized thread in the swap section, I got the engine fired up. Lots of tuning to do, but the wife had enough of the open headers. I'll get the exhaust done before I continue tuning. It sounds pretty good. It really wants to rev quick above 3000RPM.