1967 Plymouth Barracuda - Fuel tank not vented properly??????
I checker 67 supplement and nothing specific to cudas regarding venting. Here's pics from 69 manual(same in regards to 67)
View attachment 1716262689
View attachment 1716262690
Yup! Thx.
Before I saw your post, I cleaned up the vent tube, replaced the rubber hose connector to the fill tube, and rerouted it as in your figure 2.
On my 67, there is a large rectangular gasket at where the filler tube goes through the trunk floor.
Towards the center line in that gasket there was a hole with a rubber plug.
I probed that hole with a small steel wire, and I believe that ic came out on top of the fuel tank.
But with really good lighting and a small mechanic's mirror, I could not confirm that.
So, I ran the vent tube alongside the filler tube, through that large rectangular seal/gasket, and made sure it went down alongside the tank - away from the exhaust pipe.
I really couldn't see any holes in the side of the frame rail.
Will retrain myself to not overfill the fuel tank on the Cuda! :rolleyes:
Thanks all....