I need to borrow a 67 up console tach mounting base

65Val said
Those pics are not mine, and my console is together and installed now

The big hole top edge is about 1 1/8” from the top inside edge of the top plate, as per the ruler. The hole itself is 1 1/4” in size, and centered on the top plate. Those measurements, except the centering, aren’t critical as it’s all covered up when installed.

I can’t give you the mounting hole dimensions as I just used the adapter piece I had made, as a jig.

Edit: My adapter is made out of billet aluminum.

I believe those pics are mine. I just had my hands on that console today. Over time nearly every stud to hold the top to the console has been broken off. As it is a four speed console I think I will just make some plates to clamp the top to the base with the boot screws. As for the base I have one here that was machined by somebody who borrowed the original that I used to have. It came out really nice, but it a lot less hollow than that one. For those who have never had their hands on one of these, you will notice form the pics that they are NOT level. This piece will go back on my son's console with the Charger clock as his Dart has a Barracuda dash with a tach.