Flywheel questions

Newbomb Turk said
AFAIK it’s not going to be cheap.

If all you are doing is trying to get it out and checked out on your run stand, you can use a few pipe plugs to block off some of the holes and then redrill the 6 bolt pattern in it.

I’ve done that before on an 8 bolt aluminum flywheel. I wasn’t paying for a new FW after I hurt my 8 bolt crank.

I ran the hell out of it and it never failed.

That’s probably the cheapest way to get it done.

Yes! An 8 bolt pattern will clear the 6 bolt pattern except 1 bolt hole will have to be elongated if you want to go to the trouble. Here is the 8 bolt pattern marked on a 6 bolt flywheel. It's done with a Sharpie so the drawn holes should be bigger, but you get the idea.