No oil one coming out of one rocker

Take one of the end bolts out of the rocker shaft on that side. Pour oil in that hole, then rubber tipped air blower put some air pressure to that hole.

See if that drives some fresh oil out at the dry rocker.

Reassemble and give it a go again.

______________

Nick's Garage was just dealing with this on a fresh 540 cu.in. build. He back tracked it to make sure oil was finally coming up from the source and through the cam bearings.

He made sure all the valve train parts had oil on them, as he dripped oil on them by hand. (not dry)

Then he kept the drill prime tool going and turned the engine over, then the oil finally came up. It took a little time to get up there.

Then they fired it up, roller cam... it took some more time for the new lifters to fully pump up and quiet down.

All good now. Careful as you go.

(oil holes in rocker shafts pointing down, towards the exhaust manifolds.)


☆☆☆☆☆