727 Converter In All the Way?

YO7_A66 said

I felt it move twice, so with the trans being horizontal, it did not make the noise that I have read about. It just slid on further each time.

It's been a while since I have done this, and I want to make sure it's right before I put the engine back in this weekend.
Thanks!!

Click to expand...

You can be sure if you measure from the bell mounting surface of the block to the flex plate bolt surface and have just a little less than your picture measurement.

It looks in to me too, but when you put the trans in and make sure you have a small gap between the flex plate and converter as it goes in you are good.

Loctite those converter bolts.