Installing the Summit 2.5in A body exhaust
I found a few pics.
Basically used a header flange welded to the TTI down pipes, and connected them to the header back Summit 2.5" kit.
All joints were welded to prevent leaks, which is a PIA, because you have to put the entire exhaust together, tack it under the car, then remove it in sections to weld on the bench, this will prevent any leaks.
The only part that is clamped is he mufflers, also throw away the clamps that come with the 2.5" kit, they are garbage, buy some heavy clamps from NAPA.
I have still not decided if I am going to trim the ends back and install turn-downs.
I found a few pics.
Basically used a header flange welded to the TTI down pipes, and connected them to the header back Summit 2.5" kit.
All joints were welded to prevent leaks, which is a PIA, because you have to put the entire exhaust together, tack it under the car, then remove it in sections to weld on the bench, this will prevent any leaks.
The only part that is clamped is he mufflers, also throw away the clamps that come with the 2.5" kit, they are garbage, buy some heavy clamps from NAPA.
I have still not decided if I am going to trim the ends back and install turn-downs.