TTi shorty headers v ministarter

To Syleng1's points, we covered the timing and I'm using FiTech 30003 so no floats. It's getting fuel.

So maybe heat causing the resistance. I'm using large battery cables (6 gauge?) for my grounds. I checked the connection with my ohm meter from the negative terminal block to the starter case, good connection. I suppose I could try it again when it's hot, but I'll have to be careful.

The setup is the same as you see in Darter6's pic above, TTi shorty's and a ministarter (Remi, new).

As a first step, I'll lift her up and clean the connection at the wire on the starter case. It's new, but I imagine perhaps some grease or something could be on there. If that doesn't do anything, I'll put a heat shield around the starter, maybe my engine runs hotter than Darter6's. The coolant at operating temp is at 200 degrees, but those headers sure get hot.

I'll report back on findings. Thanks everyone.

brian