'70 Dart 392 Project; what direction?

208Dart said
I did the same. Toothed wheel/2 missing teeth and the 60 tooth….etc will double check but I’m pretty confident that’s it.

I pulled my sensor harness and I’m getting 5v reference, ground, and 2v on the signal pin. Same values on the Cam sensor. Going to try and reverse the signal and 5v reference wires tomorrow unless there’s a way to test sensor with it not installed in the engine?

I’d really like to find out how to display specific sensor values in Tuner studio. Can’t find my oil pressure value nor the ckp/cmp values….

Use the "Diagnostics and High Speed Loggers" tab at the top to view the cam and crank signals.

These are my settings, which are likely the same as yours if you copied the DIY site.

If you used a generic analog input for the oil pressure, you need to figure out what input you used and scale the sensor. Under advanced Engine tab, select Generic Sensor inputs. Choose the source, name it whatever you want, then enter the scale. On this same section, under tools, there is a sensor scaling tool if needed.