McCleod hydraulic throw out bearing adjust
Well hello FABO,
Took out the 67 383 A833 for test drive and notice a little slip under 3/4 throttle. Checked TO bearing back at shop and it has no front to back play.
These hydraulic TO bearings are not designed for continuous use (emailed brewers) to verify there should be play)
Although initial setup was followed, i am going to put a little play into it, but cannot remember which way it should turn to give it play.
My gut says clockwise toward the back.
So, unhook lines and turn clockwise when looking at it from front to back.
Any experience with this out there?
Thank you.
I would attach an actual pic of TO bearing but im having phone troubles so Andre is picking up the slack
Well hello FABO,
Took out the 67 383 A833 for test drive and notice a little slip under 3/4 throttle. Checked TO bearing back at shop and it has no front to back play.
These hydraulic TO bearings are not designed for continuous use (emailed brewers) to verify there should be play)
Although initial setup was followed, i am going to put a little play into it, but cannot remember which way it should turn to give it play.
My gut says clockwise toward the back.
So, unhook lines and turn clockwise when looking at it from front to back.
Any experience with this out there?
Thank you.
I would attach an actual pic of TO bearing but im having phone troubles so Andre is picking up the slack