McCleod hydraulic throw out bearing adjust

I set my hydramax with .150 air gap. That gap disappears after the first throw, and it rides on the clutch constantly while leaving room for wear, which would increase preload over time.

The Ram bearing is the same, constant contact bearing.

You have a Mcleod? The original post is edited so not seeing what you actually have.

If it is Mcleod, its the 1406-10. The problem is Mcleod instructions uses the term "clearance" instead of "Air Gap" which I think is the source of confusion.

the 1400 series Mcleod are constant contact as well, I don't want to debate Brewers... perhaps you don't have a McLeod?