McCleod hydraulic throw out bearing adjust

Muswagon said
I set my hydramax with .150 air gap. That gap disappears after the first throw, and it rides on the clutch constantly while leaving room for wear, which would increase preload over time.

The Ram bearing is the same, constant contact bearing.

You have a Mcleod? The original post is edited so not seeing what you actually have.

If it is Mcleod, its the 1406-10. The problem is Mcleod instructions uses the term "clearance" instead of "Air Gap" which I think is the source of confusion.

the 1400 series Mcleod are constant contact as well, I don't want to debate Brewers... perhaps you don't have a McLeod?

I edited the title to spell correctly.

I have a McLeod. I was able to push it back off the fingers and have 'gap'. I called McLeod to get that test to see if I had any 'gap'. So that will go away once I push the pedal. Everything you wrote seems to be right on thank you. I will report back if I have clutch slippage issues. I have been hesitant to 'send it' as I am doing my best to follow instructions and bread it in correctly, but as I previously posted, I thought I sensed something slip. Im hoping it was the rear tires. That would be great.