Looking for feedback on my rotating assembly.
Application: This is a primarily street engine with some eye towards autocross/road race use.
My goal is to match a 392 G3 Hemi for power and tq with good driveabilty and reliability.
~500HP/500TQ
394-396cid
340 Block 4.070-4.080 bore
Molnar 3.79 crank
Molnar 6.400 SBC rods
Autotech 4032 12-18cc dish pistons. (10-10.5 cr target)
1.2/1.2/3.0 summit GXP gas ported piston rings
Clevite p-series main and rod berings
Heads- edelbrock rpm, mild clean up and porting
Cam- TBD- looking in the 230-240 @.050 range
Would like to protect for an upgrade to W5 heads and 2.05 vavle if I scrounge up a set and ability to move to a 240-250 cam if power goals increase.