Spindels?
After cycling the suspension and going through the usual steps, I decided to use an offset heim joint to add about an inch of length. While this will still result in some bump steer, I’ll deal with that rather than CNCing a custom set of lower mounts. If the mock-up with these joints doesn’t work, I’ll adapt the welded-on arms, as I’ve seen on most pro-stock builds running Ford racks run custom steering arms. They either did something similar or cut off a C-body arm and welded it to the spindle. Heck, even Pintos had longer arms welded on.
pinto
After cycling the suspension and going through the usual steps, I decided to use an offset heim joint to add about an inch of length. While this will still result in some bump steer, I’ll deal with that rather than CNCing a custom set of lower mounts. If the mock-up with these joints doesn’t work, I’ll adapt the welded-on arms, as I’ve seen on most pro-stock builds running Ford racks run custom steering arms. They either did something similar or cut off a C-body arm and welded it to the spindle. Heck, even Pintos had longer arms welded on.
pinto