Can someone help with this cam ID?
So, I’m working to get near zero deck likely by putting in taller pistons but potentially by having the deck cut too. I’m trying to get my CR up to around 9.5:1 to 10.0:1
I measured how far in the hole the pistons are and they range from .092 - .107
I’m dropping my heads off at the machine shop tomorrow to have them cc’d and to have them looked over but they’re 69 X heads. Looks like they’ve been milled a little. Not sure how much though
Would the cam I have be too much for my target CR? Thinking I’ve got this one:
So, I’m working to get near zero deck likely by putting in taller pistons but potentially by having the deck cut too. I’m trying to get my CR up to around 9.5:1 to 10.0:1
I measured how far in the hole the pistons are and they range from .092 - .107
I’m dropping my heads off at the machine shop tomorrow to have them cc’d and to have them looked over but they’re 69 X heads. Looks like they’ve been milled a little. Not sure how much though
Would the cam I have be too much for my target CR? Thinking I’ve got this one: