Adding a window/inspection hole in Quicktime or similar scattershield.
I have one for weights and base adjustments and one for air gap for the clutch disc. Probably 3-1/2x3-1/2 used 1-5/8 hole saw four spots then cut off wheel to connect them. Then a single 1-5/8 one for the disc inspection. Probably wouldn’t pass cert but I figured it’s at the bottom and my feet are at the top..
I almost did it in the top if you can tell. But I didn’t want to blow any more holes in my car!
I have one for weights and base adjustments and one for air gap for the clutch disc. Probably 3-1/2x3-1/2 used 1-5/8 hole saw four spots then cut off wheel to connect them. Then a single 1-5/8 one for the disc inspection. Probably wouldn’t pass cert but I figured it’s at the bottom and my feet are at the top..
I almost did it in the top if you can tell. But I didn’t want to blow any more holes in my car!