Transfer slot Holley 1 bbl
Thank you. I set the transfer slot. Replaced the filter. Set my mixture screw to where it was , 1 1/2 out. Float was good ,needle and seat replaced. The e clip on the float pivot pin was missing. Obviously someone has been in this carb over the last 60 years. Metering block screws weren't very tight. Pcv hose is as rigid and hard as a plastic pipe! Advance works on dizzy. A shot of carb clean under the throttle blade and it fired. Another shot and it ran. I had to play with the throttle for a moment but then it ran on its own. Let it warm up. Havent adjusted mixture with a vacuum gauge yet. After lunch. Thank you for your advice. BTW stock airfilter assembly.