727 parts needed for RB install in a 69 barracuda

My original throttle cable does fit, just a little too tight around the MP valve cover, and the plastic jacket is long gone. I ordered a "correct" throttle cable from Mancini, what a POS it is. I will have to rework it to make it work. ferrule crimps are almost non-existent, and the wire length is over an inch too long. I might just swage a new stop on it and rework the ferrule crimps. Everything else seemed to work well including my new driveshaft. I did get a messed up MOOG problem creator u-joint for 7290 to 7260. The kit had 3 7290 caps and only 1 7260. I had a few other 7260 joints so just used a cap from one of them. Have seen that story before...