Finally get to pretend I am one of the cool kids - Holley kit swap

Dantra said

Yea, I knew you didn't really there.. That's why I was surprised at first loo, it looked like yours.

Honestly.. I don't think holley is gonna give 2 ***** and people have dealt with it.

You could use a cutoff wheel and widen the slots to the pass side.. Then build a bead down the other side and smooth it.

Just throwing ideas until something sticks. I wanna see this done lol
:steering:

Click to expand...

I don't think Holley will care either. Pretty sure the response would be; "A friggin eight of an inch?? Call us back when you have a real problem".

Don't think I will touch the k-frame. My gut says it is in the Holley mounts. And if a cutoff wheel and welder touch anything it will be those. I just have to decide if I want to delay the crossmember and tunnel work to do that or if I am going to ignore it.

I could save it for later; build the new crossmember and trans mount with some adjustability (clearance and slots) so that I can build it square now and put the new motor in right later. Not sure.