Finally get to pretend I am one of the cool kids - Holley kit swap

DionR said

If I mess with the mounts, I will create a jig of some type to so I can feel somewhat confident that I can get it right. I don't think I would have to cut the tubes free from the plates on the mounts, just cut the mounts at the engine plate side and fit them up and weld them back on. I can see it in my mind, but that generally doesn't go like I imagine.

Click to expand...

When I was making Hooptys mounts, I had to draw out the mounts with correct angles and to scale, when I wanted to shift to one side.. I made a prototype set of mounts from cardboard, while the motor was sitting where I wanted. The Hemi block is 45 degrees (close enough) and then I got the angle off the mounts and width of my perches and worked from there. It can be a little tricky to shift to one side and not cause a lean or change height. Put some osb between the pan and k, and just let it set little there and shift it around a little. You got this.. this is nothing man. Or.. a deadblow