73 E body front disc brakes conversion on A body. Where did I mess up?

67Dart273 said
You can reverse them side to side. Some of us mounted the calipers on rear to guarantee anti sway bar clearance especially for after market ones. You must also reverse the calipers side to side to put the bleeders at the top

I'm speaking in this case of the 73/ later A body single piston, which were factory on the front, but swapped side to side to put the calipers towards the rear. Same thing.

Also I think? the E body upper A arms don't fit? What are you doing there?

The lower ball joint forces me to aim tie rod connector to the opposite side of the caliper which would be towards the front with caliper at rear. All steering linkage is rear of knuckle. This means I cannot swap sides but there is a left and right. I must be missing something. Can only get the lower ball joint to go on one way. This would be passenger side.

Have new QA1 UCA

20241211_150136[1].jpg