340 cam for 318

Well now…I sent a message a bit ago to a fella who works for with Delta cams or Oregon cams. I don’t recall, but he’s a member on the board I normally go to.
I’ve asked hom to build me a cam card on the cam I have, then I’ll go from there. If the juice isn’t worth the squeeze, I’ll just run it as is.
If a wider? LSA than was recommended here, I’ll ask about thought of advancing it for low end compression. If all done at 4-4500 I’m good with that.
Cam will be out during Xmas, and will wait until the shipping rush is over.

Heck, I mailed out a MO on Saturday, still not there yet.