Right now my rear leaf springs are in their stock location on the dowel pin centered on the rear end perch.
I have always been bothered about how close the front of the rear end is to the wheel opening in my case about an inch an an eighth away from the wheel lip.
I was looking over the rear spring perches this evening and I noticed that the was a round hole in the center of the perch, and two square holes on the perch one located about 1.5 inches forward and one 1.5 inches aft.
Could a guy just loosen the clamps drill the front perch so it would accommodate the locating pin and relocate the pin the the forward position, which would relocate the rear axle aft?
Me thinks this would look much better but is there some geometry or other issues to consider?
View attachment 1716342644View attachment 1716342645