De-Pin a headlight switch connector

the end fold over type are for senders that use a nail head type stud like your oil or coolant temp sender


I'd be finding out where that red wire goes...
if it is the feed to the interior light, id re wire the interior light... if the wires on the back short to the roof the insulation on the whole run down the screen pillar back to the switch gets burnt and you end up melting the connector.

use the old wire to pull the new wire up through the screen pillar and across the roof.


if its to the headlights well there is potentially evidence of a case of the wrong wattage bulbs being used at some point in the past