Yawnnnn. Bla bla bla.
You’re comparing the same head which is fair.
Your not comparing the same level of work don’t to the heads ports. Not fair.
The Bloomer head is larger in cc’s leading to a belief that the port is carved differently and is superior. With this info and other posted in the heads cfm results, I do believe the head, at least on paper, is better and has better ports. I don’t think this is an argument.
The smaller port has been done so by the company as a safe porting (if ported) so there is no issues and leaves room on the table. On purpose.
It’s just a whose port is better. The are route taken by the company for the hope of zero issues anywhere or the full tilt (or close to full tilt) customer ported highly developed highly researched porting.
Does this make sense?
This is what I was trying to simply say but fat head above who now is starting to loose his **** and drag other people accomplishments into his argument isn’t reading or understanding but just being hard headed for his big friend in secret- Mr. bloomer - I’m not crappin on Mr. Bloomer.
What you have as another difference is a readily available head (or soon to be) from AFR VS a guy custom porting as many as he can with his desired level of quality.
Big difference on the same casting.
If not, OK, no worries.
Ether way, I’m walking away from this argument as it’s stupid to make this point dragged out agreeing and disagreeing with the guy loosing his **** over his boyfriend’s cylinder head. It’s F’in crazy.
I say to bad the Bloomer head isn’t mass produced so everyone can get it like someone else thinks they can because they are on the shelf or produced in a day and ready to be shipped in the morning.
Good day gents!