63 Dodge Dart, now let me see;)
I'm getting really good a stabbing the A833 back into its home. I put it back together including the exhaust just to check the possibility of a slave push or pull vs internal T.O. bearing.
First off it's really difficult to get a decent pic, need a 3d camera! lol
how about a "bracket" coming from the transmission crossmember or torsion bar thing. Then it could Pull.
Same statement a couple pics up, bracketry off the trans tunnel, to install a pulling slave cylinder. didn't say I was going to do it, would 1.5" travel be enough to disengage the clutch?
Looks doable, but the exhaust sweeps up and terribly close to where the slave would go if it were to pull.
I'm getting really good a stabbing the A833 back into its home. I put it back together including the exhaust just to check the possibility of a slave push or pull vs internal T.O. bearing.
First off it's really difficult to get a decent pic, need a 3d camera! lol
how about a "bracket" coming from the transmission crossmember or torsion bar thing. Then it could Pull.
Same statement a couple pics up, bracketry off the trans tunnel, to install a pulling slave cylinder. didn't say I was going to do it, would 1.5" travel be enough to disengage the clutch?
Looks doable, but the exhaust sweeps up and terribly close to where the slave would go if it were to pull.