Low compression 360 cam suggestions
Have you seen when you order a cam, get it, check it, and its not what you ordered?
Are you asking if the cam is boxed wrong(part number on cam and box don’t agree), or the part number is not what you ordered?
Or the measured specs are not correct for the number on the cam?
I don’t recall having any of those scenarios play out.
Edit- I take that back……..
I had a SBC roller cam that was pretty far off the advertised specs.
It also didn’t really match any of that suppliers other catalog cam specs.
Cam was an off the shelf grind with the part number stamped right on it.
I was discussing it with a customer who also had a cam from this supplier. I urged him to measure his cam…….which he did……and it was also pretty far from the advertised specs.
I’m remembering a couple of others…..
One was a cam from a friends Pontiac stocker…….there was an issue with all the exhaust lobes not getting finished correctly.
Another was a lift rule oval track cam for a SBC where the exhaust lobes didn’t measure what the lobe master sheet called for.
There was the typical “that’s impossible” talk from the grinder, but in the end, it turned out that the lobe master had been made wrong.