Hedman Header Installation Help Needed

Done!! I'll update my signature pic and you'll be able to see it.

So without further delay, here is what has to happen to install headman headers in a 68 Cuda with a 340, 727, and power steering.

1. Drink heavily...before hand, you'll need it. :occasion:
2. Jack car up as high as possible (at least 1.25') and install jack stands.
3. Unbolt motor mounts.
4. Disconnect center link from steering box arm and drivers side tie-rod.
5. Jack engine up as high as possible.
6. Lay passenger side header under engine (grunt groan cuss and get pissed cause it's way harder than it sounds) :scratch:
7. Let engine back down slightly
8. Call wife out to garage.
9. Order your drink :occasion:
10. Crawl under car with left side header, crawl back out and orientate header correct way, repeat as neccesary, crawl back out and jack car up higher, reposition jack , repeat again..... :x
11. Slide header in from bottom until it contacts with the cylinder head.
12. Call wife back out to garage..another drink please, and please give me a hand once I finish this drink. :occasion:
13. Have wife use largest bar in garage to pry engine towards the passenger side and pull header up to mounting location.
14. Have another drink :occasion:
15. Maybe one more drink, this job sucks ***. :occasion:
16. Lower engine, verify that mounts are as they should be.
17. Slide in gaskets and bolt headers into place and take pictures.
18. Re-attach steering gear--schedule alignment.

Thanks for all the help fellas.
:supz: