wrist pin install

One the pin will not come out unless the locks are not install properly. With press fit there is always a chance it's not tight enough and will loosen up and the pin sides into the cylinder wall. I only do floating but that's me. My dad only does press fit. It's a personal choice.
There is also the theory more hp because the piston rod assembly has two pivot points instead of one. I've never seen a dyno test on that one yet.
Also their are a few machinist that say steel on steel is ok but I wouldn't trust it for street use. Have them bushed and an oil hole drilled on the top of the rod if you go that route.