349 CI on the cheap

Hey Rumble,,whatsssup...yea i did math and the 1.72" pin height is perfect..

3.51"/2= 1.755" + 1.72"= 3.475" + 6.123"= 9.598"

I allready scored a crank a few week ago,i have an 86 318 roller block and picked up a complete set of oem hyd. roller tappets with dog bones and the spider for $45.00 on ebay..now watching for the perfect hyd. roller cam..

I found the perfect piston for this at summit,or other places,,part #TRW-8K285NCP.. I now need too score a set of pushrods off ebay to keep cost down,,this should be a low buck yet very well performing combo,,i have a set of 302 and 574 mopar 340 replacement heads as well as 2 set of w2's and a couple of sets of j heads,,so i gotta decided,,i'm thinking the 574's would be perfect,,good thread by the way,,i'm in,,waynebo