I might cry

My last stroker cost Just under 2000.00 for my last machine job. This was the short block only. No parts incl. The job included;
1. Boiling and blasting block.
2. Boring block from 3.91" bore to 4.025" bore.
3. Finish honing with torque plate to 4.03" bore
4. Alighn hone.
5. Install oil gallery tube and drill from main saddles.
6. Deck block to 9.580"
7. Sonic test block

Block had already been pressure checked.
Prior stroker was about the same from another high-quality shop.
Balancing was already done.
This is about the going rates around here.
Assembly would depend on how serious the work would entail, ie, file-fit rings, dial in cam, excet.........